Oil and gas recovery in chemical storage tank area, one-stop solution for Luoyang Wohong pry installation device

Oil and gas recovery in chemical storage tank area, one-stop solution for Luoyang Wohong pry installation device

The recovery of oil and gas in the chemical storage tank area is difficult in the intermittent emission of exhaust gas, large concentration fluctuations and high explosion-proof requirements. When the feed, discharge or temperature of the storage tank changes, the concentration of organic matter discharged by the breathing valve is high and low. Traditional processing equipment either has slow response, high energy consumption, or frequent maintenance.

The skid-mounted oil and gas recovery unit of Luoyang Wo Hong adopts the combined process of compression condensation and membrane separation, which is specially designed for the working conditions of the storage tank area. The exhaust gas enters the condensing unit after being pressurized by the compressor, and part of the organic matter is directly liquefied and recovered; the uncondensed exhaust gas enters the membrane module, and the organic matter preferentially passes through to form concentrated gas, which is sent back to the front end of the system for circulating treatment, and the air is discharged up to the standard. The whole system is operated in closed circuit, and the emission concentration meets the current environmental protection requirements.

The device adopts skid-mounted design, the compressor, condenser, membrane module and control system are integrated on the steel base, and the assembly and debugging are completed before leaving the factory. The site only needs to connect the power supply and connect the breathing valve pipeline to run, and the installation cycle is short. The equipment covers a small area and can be placed in the open air, which is suitable for the site conditions of the storage tank area.

The equipment is driven by electric power, there is no combustion process, no open flame, and it has good applicability in explosion-proof areas. Not in operationactivated charcoalReplacement of consumables, do not produce hazardous waste. The control system automatically starts and stops according to the exhaust situation of the breathing valve, works when there is gas, and stands by when there is no gas, so as to avoid energy waste caused by continuous operation. Routine maintenance is mainly to check the pressure difference on both sides of the membrane module and clean the surface of the heat exchanger.

For the oil and gas recovery project in the chemical storage tank area, Luoyang Wo Hong skid-mounted device can realize material recovery while meeting the emission requirements. Site survey can be arranged before selection, according to the number of tanks, material types, breathing valve configuration matching equipment specifications. The skid-mounted unit is quickly put into place and put into operation on site, which is suitable for the transformation of storage tank area or new construction project.